These Tips Improve your Road Milling Bits Lifespan

When it comes to road milling, road milling bits are some of the most exposed parts to wear. Since they are the main cutting tools, they are highly like to wear off faster than any other part. In fact, cutting tools makes a huge chunk of the maintenance cost in most of the construction companies. However, there are ways that you can go around it to ensure your road milling bits serves for longer.  In this article, we are going to explore some of the things that can help you improve the lifespan of your milling bits.

Milling the Right Surface

One of the major mistakes that most operators commit is milling any surface. It is a common problem with small contractors who are usually struggling with machinery capacity. But the practice ends up doing more harm to the investor rather than good. So if you have an asphalt milling bit and you end up using it on concrete surfaces, then you are like to increase the rate of wear and tear of the bits. So you must ensure that road milling bits are used for the right surface. Otherwise, you will end up increasing the rate of wear and tear of the bit and thus reducing its lifespan significantly.

Make repairs

Just like any other part, milling bits can also be repaired. In most cases, the bits are exposed to extremely harsh conditions and thus exposing them to a high rate of wear and tear.  For instance, you may find out that the carbide tip of the bit has been dulled or blunt after milling tough surfaces. In such cases, it may not be necessary to have to make a replacement, but a repair will work. You can have the bit tip sharped to ensure continued performance of the milling machine. But if the repair does not work or the damage is beyond repair; then you should consider replacing with a brand new.

Proper Milling

When it comes to actual milling, there are a few things that are important to consider. The most important of all is to ensure that it is done properly. The speed of the machine matters a lot, and it has an impact on the condition of the bits. The milling machine should be operated at a very considerate speed. But rushing or milling at very high speed puts a lot of pressure on the bits and this, it is likely to increase the level of wear. The result is a reduced lifespan of the milling bits.